Rose Electronics CrystalView EX5 DVI - Manual (Page 13)

CrystalView EX5 Installation and Operations Manual 9
Connecting USB Devices
Up to 13 USB 1.1 or 2.0 devices can be connected to the Receiver unit
using USB Hubs. Normally the three USB Type A connectors on the
Receiver are connected to a USB Keyboard, USB mouse, and a USB Hub.
Installing your USB devices is no different than installing them when
connected directly to a computers USB port.
1. Install the USB device according to the manufactures procedure and
any required software to operate the USB device
2. Connect the USB device to the Receiver’s USB ports or a HUB port
3. Verify that the operating system has recognized the USB device and, if
needed, installed the proper drivers to operate the USB device
4. Test the USB device
Each USB Type A port on the Receiver unit can supply up to 500ma to a
USB device or USB Hub. When connecting additional USB devices through
a USB Hub, consider the total current needed to operate all of the USB
devices. If the total power is greater than 500ma, use a powered Hub to
supplement the power to the devices.
The CrystalView EX5 is compatible with a wide variety or graphic cards,
monitors, USB devices, and operating systems.
System Operation
The operation of the CrystalView EX5 is no different than operating your
computer with your keyboard, monitor, mouse, and USB devices directly
connected to it. The only difference is the computer can be located
anywhere within 330 feet from the Receiver unit. Applications can be
executed, files opened, edited, and saved, upgrades can be performed and
normal system operations can be performed as if you were directly
connected to your computer.