Rugged Cams ELX DVR 16 Channel - Manual (Page 13)

Basic Configuration ELX16-240
Rugged CCTV.
2003.09.06 (v 1.0) 13
3.4. Viewing all channels with sequence mode
There are two modes; basic sequence mode and user sequence mode. User sequence mode runs when
pressing the [SEQ] button during 1 second or above.
3.4.1. Basic sequence mode
- All channels can be viewed in successive order automatically using the [SEQ] button.
- Press the [MENU] button on the front panel to set -up the sequential cycle. (The default value is 3
seconds per channel for display .)
- Select “M onitor A ” menu of “Monitor” tab among Configuration menus. And press the [ENTER] button.
- Select “Seq. Switching(sec) ” and set any value between 1 and 60 seconds.
- In order to move to sequence mode from any viewer mode, press the [SEQ] button.
- In order to exit from sequence mode, press the [SEQ] button once again.
<Note>
Sequence mode can run only when connected and activated cameras are more than split screen. With
single full screen mode, activated cameras should be two or more. With quad-sp lit screen mode, there
should be five or more activated cameras . In 16 / 13 spilit mode, sequence mode can’t be used.