Emerson iC200 - Manual (Page 35)

34
Wake To Your iPod ®
NOTE: You can only wake to the “Dockable” iPod ® . You cannot wake to the
iPod ® Shuffle.
1.) Connect your iPod ® to the docking station as usual, start playback, select the
song that you would like to play at the wake up time and the desired volume
level, then press the Power button to shut the system ‘Off’.
2.) Slide the Alarm 1 and/or
Alarm 2
selector switches,
located on the left side panel
to the iPod position.
The AL 1 and/or AL 2 indicators will appear in the main display to confirm that
the alarms are ‘On’.
3.) At the selected wake up time the system will turn on in the iPod ® mode to the
song you selected.
NOTE: If you selected the song from the iPod ® Songs menu, playback will
stop when that song ends. If you selected the song from within the iPod ®
Album menu, playback will continue for one hour or until the end of that
Album, whichever comes first.
4.) To stop the iPod ® alarm sooner press the Power button or the appropriate
Alarm 1
or Alarm 2 buttons on the top panel.
NOTES:
• If you selected the “Wake To iPod ® ” option but there is no iPod ® connected
to the docking station at the wake up time, the alarm automatically defaults
to the “Wake To Buzzer” option.
• You cannot wake to an iPod ® Shuffle because the Shuffle has no interface
to receive the alarm signal from this system. If you selected the “Wake To
iPod ® ” option but you are using an iPod ® Shuffle, the alarm will automatically
default to the “Wake To Buzzer” mode.
iC200_042007.p65 20/4/2007, 15:43 34