Emerson iC200 - Manual (Page 6)

5
P R E PAR AT I O N F O R U S E
Unpacking and Set Up
• This carton contains the main unit, the remote control hand set, iPod ® Support
Bracket and 5 different iPod ® adapters so that you can securely connect any
dockable iPod ® to the top mounted docking station. Remove all of the
components from the carton and remove all packing materials from the
components. We recommend that you save the carton and packing materials
if possible in the event that your system ever needs to be retuned for service.
Using the original carton and packing materials is the only way to protect you
unit from damage in transit.
• Remove any descriptive labels from the top or front panels of the main unit. Do
not remove any labels from the back or bottom panels.
• Place the main unit on a stable, level surface such as a table, desk, or shelf,
convenient to an AC outlet, out of direct sunlight, and away from sources of
water, moisture, heat, dust, dirt, vibration, or strong magnetic fields.
NOTE: The speakers in this system are not video shielded therefore it is
not recommended to place this unit on top of your TV set. The magnets in
the speakers could cause some color distortion in your TV picture.
• Unwind the AC power cord and extend it to its full length. This is important. The
FM antenna is built into the AC power cord and must be fully extended for best
FM reception.
Protect Your Furniture
This model is equipped with non-skid rubber ‘feet’ to prevent the product from
moving when you operate the controls. These ‘feet’ are made from non-migrating
rubber material specially formulated to avoid leaving any marks or stains on your
furniture. However certain types of oil based furniture polishes, wood preservatives,
or cleaning sprays may cause the rubber ‘feet’ to soften, and leave marks or a
rubber residue on the furniture. To prevent any damage to your furniture we strongly
recommend that you purchase small self-adhesive felt pads, available at hardware
stores and home improvement centers everywhere, and apply these pads to the
bottom of the rubber ‘feet’ before you place the product on fine wooden furniture.
iC200_042007.p65 20/4/2007, 15:43 5