Extron electronic MTP 4T 15HD RS - Manual (Page 10)

MTP 4T 15HD RS • Installation and Operation
Installation and Operation, cont’d
2-4 MTP 4T 15HD RS • Installation and Operation 2-5
5. Reliable earthing (grounding) — Reliable earthing
of rack-mounted equipment should be maintained.
Particular attention should be given to supply connections
other than direct connections to the branch circuit (such as
the use of power strips).
Installation instructions
Mount the MTP 4T 15HD RS in a rack as follows:
1
. If feet were installed on the bottom of the transmitter
assembly, remove them.
2 . Attach the included rack/through-desk mounting brackets
(part #70-077-03) to the unit using eight machine screws
supplied with the mounting kit.
#8 Screw
(4 Plcs)
Each Side
Figure 2-2 — Attaching the mounting brackets
3 . Insert the unit into the rack and align the holes in the
mounting brackets with the holes in the rack. Use four
machine screws to attach the brackets to the rack.
Connections and Settings
See figure 2-3 to identify the rear panel connections on the
transmitter.
50/60 Hz
100-240V .3A
OUTPUT INPUT
Tx Rx
RS-232
MONITOR
PRE-PEAK
ON
OFF
MTP T 15HD RS 1
INP
Tx
6 5 1 3 2
4
2
Figure 2-3 — Transmitter assembly’s rear panel
features
There is one item a , powering all four transmitters.
There are four items b through f , one for each
transmitter.
a
AC power connector — Plug a standard IEC power cord into
this connector to connect the transmitter assembly to a 100 VAC
to 240 VAC, 50 or 60 Hz power source.
b
Input video connector — Connect a
computer video source to this 15-pin HD
connector for high resolution video input.
N Input only sync signals, no video
signals, on the sync pins, 13 and 14.
For component video, use the R (R-Y) and R return pins
(pins 1 and 6), G (Y) and G return pins (pins 2 and 7),
and B (B-Y) and B return pins (pins 3 and 8).
For S-video, use the R, R return (C-chroma), G, and G
return (Y-luma) pins.
For composite video, use the G pin and the associated
return pin. For additional genlocked video signals, use
the R, B, and associated return pins.
N If the video input is HDTV/component video with
tri-level sync, the transmitter’s jumper setting must be
changed. See “Setting the Transmitter Sync Jumper
(Component Video)”, on page 2-2.
5 1
15 11
6 10
Female