Extron electronic MTP 4T 15HD RS - Manual (Page 11)

MTP 4T 15HD RS • Installation and Operation
Installation and Operation, cont’d
2-6 MTP 4T 15HD RS • Installation and Operation 2-7
c
Monitor connector — Connect a video monitor to this 15-pin
HD connector for buffered, high resolution video loop through.
d
RS-232 connector — Connect a serial communications device
to this 3.5 mm, 3-pole captive screw connector for bidirectional
RS-232 communication. Wire the connector as shown in figure 2-4.
Ground
Tx
Rx
Gnd
Receive
Transmit
Connected RS-232
Device Pins
MTP
Pins
Figure 2-4 — RS-232 connector wiring
N By default, the RS-232 portion of the TP link is
unidirectional only from the transmitter to the receiver.
If there is only one receiver in a system, a jumper
within the receiver allows the RS-232 communication
to be bidirectional. Refer to the MTP 15HD RS Series
manual.
e
Pre-Peak switch — The Pre-Peak switch alters the TP signal
output to correct for long cable runs. See the table on page 1-4
for suggested switch settings based on the transmitted video
format and transmission distance.
f
Transmitter Output connector — Connect one end of a TP cable
to this RJ-45 female connector on the transmitter.
C Do not connect this device to a computer data or
telecommunications network.
Connect the free end of the same TP cable from the transmitter
to the receiver’s Input RJ-45 female connector.
See “TP cable termination” on the next page to properly wire the
RJ-45 connectors.
TP cable termination
N RJ-45 termination with CAT 5, CAT 5e, or CAT 6
cable must comply with the TIA/EIA T568A or
TIA/EIA T568B wiring standards for all connections.
RJ-45 termination with Skew-Free A/V UTP cable must
comply with TIA/EIA T568A only.
Figure 2-5 shows the recommended termination of TP cables in
accordance with the TIA/EIA T568A or TIA/EIA T568B wiring
standards. You can use either standard with CAT 5, 5e, or 6
cable, but use the same standard on both ends of the cable.
5
Pin
1 Red+/V. sync+
2 Red–/V. sync–
3 Mono audio+
Green–
6 Mono audio–
7 Blue+/H. sync+
8 Blue–/H. sync–
4
Wire color
White-green
NOTE If you are using Enhanced Skew-Free™ A/V
cable, use the TIA/EIA T568A standard only.
Green
White-orange
White-blue
Orange
White-brown
Brown
Wire color
T568A T568B
Signal
White-orange
Orange
White-green
White-blue
Green
White-brown
Brown
Side
Green+ Blue Blue
12345678
Insert
Twisted
Pair Wires
Pins: RJ-45
Connector
Figure 2-5 — TP cable termination
N Enhanced Skew-free A/V cable is not recommended
for Ethernet/LAN applications. This cable is specially
designed for compatibility with Extron’s Twisted Pair
products that are wired using the TIA/EIA 568 A
standard.
The green, brown, and blue pairs of this cable have
virtually identical lengths and should be used to
transmit the RGB signals.
The orange pair of this cable has a different length and
should not be used to transmit the RGB signals.