DE DIETRICH LZ9619E1 - Manual (Page 11)

Building-in
c) Mounting the door
Fix the hinges to the machine by means of
the M5x9 screws (3-Fig. B). The hinges can
be adjusted to compensate for possible
uneven thickness of the door.
To align the door perfectly it is necessary to
loosen the screw (3-Fig. B), adjust the door
and tighten the screw again.
d) Counter-magnet (6)
The appliance is pre-arranged for a
magnetic closure of the door. To enable a
correct operation of this device, it is
necessary to screw the counter-magnet (6)
(steel disk + rubber ring) into the inner side
of the door.
Its position must correspond to the magnet
(4) on the appliance (see picture D).
P0984
6
4
D
If the door has to be opened from left to
right, proceed as follows:
• remove the magnet (4) and the plates (5)
on top and on the bottom (Fig. B).
• Move plates (7) from left to right (Fig. A
and E).
• Fit the magnet (4) again as per picture E.
4
6
5
1
2
3
7
E
P0983
GB
11