DE DIETRICH LZ9619E1 - Manual (Page 21)

GB
21
How to wash
11. Cancelling a programme
To cancel a programme which is running,
turn the programme selector dial to the
RESET
position: three flashing dashes
will be displayed.
Warning! After a programme which ends
with water in the drum (RINSE HOLD
option), turn the selector dial first to
and
then to the DRAIN programme .
12. Altering a programme
which is running
To alter a programme, first set the machine
to PAUSE by pressing the START/PAUSE
button .
Before the machine starts the heating
phase, i.e. within the first 15 minutes for
cotton programmes, 10 minutes for synthetic
and delicate programmes and 5 minutes for
the wool programme, the selected wash
cycle can be modified.
Warning! If the programme selector dial is
turned first to RESET
and then to the
new programme, the programme which is
running is cancelled, the water is emptied out
and the machine re-starts from water filling.
To simply modify the programme which is
running, turn the programme selector dial to
the desired position (avoiding the RESET
position): when the START/PAUSE button is
pressed again, the machine restarts with the
newly selected programme from the point at
which it was interrupted.
13. Opening the door after the
programme has started
The door can only be opened before the
machine starts the heating phase (within the
first 15, 10 or 5 minutes, depending on the
programme selected - see paragraph above)
and during the rinse phase.
Set the machine to PAUSE (by pressing the
START/PAUSE button).
If the door does not open, this means that
the machine is already heating, or that the
water level is above the bottom edge of the
door.
This prevents water from spilling out when
the door is opened.
14. At the end of the programme
The machine stops automatically and three
flashing zeros are displayed.
The STOP and spin speed pilot lights, as
well as the pilot light(s) corresponding to the
selected option(s), stay on.
If the RINSE HOLD option has been
selected, the corresponding pilot light on the
programme progress display flashes to
indicate that the water must be emptied out
before opening the door.
The pilot light of the START button flashes
and tree flashing zeros are displayed.
Release of the lock is indicated by an
audible signal.
Turn the programme selector dial to
RESET
.
Switch the machine off by pressing the
ON/OFF button
.
Remove the laundry from the drum.
Check that the drum is empty so as to avoid
a subsequent wash being damaged by any
forgotten items.
Close the water tap.
Leave the door open to prevent the
formation of mildew and unpleasant smells.