DE DIETRICH LZ9619E1 - Manual (Page 9)

Installation
Electrical connection
(LZ 9619 E1)
This machine is designed to operate on a
220-230 V, single-phase, 50 Hz supply.
Check that your domestic electrical
installation can take the maximum load
required (2.2 kW), also taking into account
any other appliances in use.
Connect the machine to an earthed socket.
The manufacturer declines any
responsibility for damage or injury
through failure to comply with the
above safety precaution.
Should the appliance power supply
cable need to be replaced, this
should be carried out by our Service
Centre.
Important! The power supply cable must be
easily accessible after installing the
machine.
Electrical connection
(LZ 9619 U1)
Any electrical work required to install this
appliance should be carried out by a
qualified electrician or competent person.
The machine is designed to operate on a
230-240 V, single phase, 50 Hz supply.
WARNING: THIS APPLIANCE
MUST BE EARTHED.
The manufacturer declines any
liability should this safety
measure not be observed.
The appliance is supplied with a 13 amp
plug fitted. In the event of having to change
the fuse in the plug supplied, a 13amp
ASTA approved (BS1363A) fuse must be
used.
Should the plug need to be replaced for any
reason, proceed as described below:
Green and Yellow - Earth
Blue - Neutral
Brown - Live
The wire coloured green and yellow must be
connected to the terminal marked with the
letter «E» or by the earth symbol
or
coloured green and yellow.
The wire coloured blue must be connected
to the terminal marked «N» or coloured
black.
The wire coloured brown must be connected
to the terminal marked «L» or coloured red.
Upon completion there must be no cut, or
stray strands of wire present and the cord
clamp must be secure over the outer
sheath.
A cut off plug inserted into a 13
amp socket is a serious safety
(shock) hazard.
Ensure that the cut off plug is
disposed of safely.
Should the appliance power
supply cable need to be replaced,
this should be carried out by our
Service Centre.
Important! The power supply cable must be
easily accessible after installing the
machine.
GREEN & YELLOW
BROWN
CORD CLAMP
BLUE
13
A
P1041
E
N
L
GB
9