Extron electronic HSA 200SE - Manual (Page 19)

HSA 200/222 Series • Maintenance and Modifications HSA 200/222 Series • Maintenance and Modifications
Maintenance and Modifications, cont’d
3-6
4 . Remove the four 1/16" hex head screws on the right and
left sides of the front panel (figure 3-3). Retain the screws.
Lift the panel away from the enclosure.
Figure 3-3 shows an HSA 200 model. Removing the
front panel from an HSA 222 is an identical procedure.
Lift p a nel o u t
of enclo su re.
Remove 2 hex he a d
s crew s on e a ch s ide.
240 - 50/60 Hz 5A
HSA 200
AUDIO
Figure 3-3 — Removing the front panel
5 . With a Tweeker, push down on and
gently twist on the front of each RJ-45
connector detent to disconnect the
connector from the rear of the front panel
plug-in.
6 . Pinch the top and bottom bezel detents
together and push the bezel through the
front panel.
7 . Snap a replacement bezel in place. If necessary, replace the
connector icon by prying the old icon off of the connector
plug-in with a Tweeker (figure 3-4) and snapping a new
icon in place.
Icon La b el
Figure 3-4 — Changing the connector icon
8 . Snap the internal RJ-45 connector onto the back of the front
panel enclosure bezel plug-in.
9 . (HSA 222 models only) Reach your hand through the
front panel access hole and snap the lower internal RJ-45
connectors onto the back of the lower enclosure bezel
plug-ins.
10 . Replace the front panel in the surface mount enclosure and
secure it in place with the hex head screws removed in
step 4.
11 . (HSA 222 models only) Replace the front access panel in
the surface mount enclosure and secure it in place with the
Philips head screws removed in step 2.
12 . (HSA 222 models only) Reinstall the surface mount
enclosure. See Removing and Replacing the Enclosure, steps 6
through 11.
3-7