Extron electronic HSA 200SE - Manual (Page 24)

HSA 200/222 Series • Reference Information HSA 200/222 Series • Reference Information
Reference Information
A-3 A-2
Specifications
Video — HSA 200SE, HSA 200CE
Gain ................................. Selectable: unity (0.7 V), (0.75 V) 50%, (0.8 V)
100%
Bandwidth ..................... 300 MHz (-3 dB)
ID bits are terminated on pins 4 and 11.
Video input — HSA 200S, HSA 200C
Number/signal type .... 1 VGA–UXGA RGBHV, RGBS, RGsB, RsGsBs
Connectors ..................... (1) 15-pin HD female
Video input — HSA 200SE, HSA 200CE
Number/signal type .... 1 VGA–UXGA RGBHV, RGBS, RGsB, RsGsBs
Connectors ..................... (1) 15-pin HD female
Nominal level ................ 0.7 Vp-p for RGB
Min./max. levels ........... Analog: 0.3 V to 1.5 Vp-p with no offset at unity
gain
Impedance ...................... 75 ohms
Horizontal frequency ... 15 kHz to 135 kHz
Vertical frequency ......... 30 Hz to 170 Hz
Video output — HSA 200S, HSA 200C
Number/signal type .... 1 pass-through VGA–UXGA RGBHV, RGBS,
RGsB, RsGsBs
Connectors ..................... 5 BNC female on pigtails
Video output — HSA 200SE, HSA 200CE
Number/signal type .... 1 VGA–UXGA RGBHV, RGBS, RGsB, RsGsBs
Connectors ..................... 5 BNC female on pigtails
Nominal level ................ 0.7 Vp-p for RGB
Min./max. levels ........... Analog: 0.3 V to 1.5 Vp-p
Impedance ...................... 75 ohms
DC offset ........................ ±5 mV with input at 0 offset
Sync — HSA 200SE, HSA 200CE
Input type ....................... RGBHV, RGBS, RGsB, RsGsBs
Output type ................... RGBHV, RGBS, RGsB, RsGsBs
Input level ...................... 2.0 V to 5.0 Vp-p
Output level ................... TTL: 5.0 Vp-p, unterminated
Input impedance ........... 510 ohms
Output impedance ........ 75 ohms
Max. propagation delay 18.8 ns
Max. rise/fall time ........
4 ns
Polarity ........................... Positive or negative (follows input)
Audio — HSA 200SE, HSA 200CE
Gain ................................. Unbalanced output: 0 dB; balanced output: +6 dB
Frequency response ...... 20 Hz to 20 kHz, ±0.5 dB
THD + Noise .................. 0.025% @ 1 kHz, 0.020% @ 20 kHz at nominal
level
S/N ................................. >90 dB at rated maximum output (21 dB,
balanced)
Stereo channel separation >75 dB @ 20 Hz to 20 kHz
Audio input — HSA 200S, HSA 200C
Number/signal type .... 1 stereo, unbalanced
Connectors ..................... (1) 3.5 mm stereo female jack
Audio input — HSA 200SE, HSA 200CE
Number/signal type .... 1 stereo, unbalanced
Connectors ..................... (1) 3.5 mm stereo female jack
Impedance ...................... >10k ohms unbalanced, DC coupled
Nominal level ................ -10 dBV (316 mVrms)
Maximum level ............. +6 dBu, (balanced or unbalanced) at 1%THD+N
Audio output — HSA 200S, HSA 200C
Number/signal type .... 1 pass-through stereo, unbalanced
Connectors ..................... (1) 3.5 mm, direct insertion captive screw
connector, 3 pole
Audio output — HSA 200SE, HSA 200CE
Number/signal type .... 1 stereo, balanced/unbalanced
Connectors ..................... (1) 3.5 mm direct insertion captive screw
connector, 5 pole
Impedance ...................... 50 ohms unbalanced, 100 ohms balanced
Nominal level ................ Unbalanced output: -10 dBV (316 mVrms)
Balanced output: -2 dBu (632 mVrms)
Max. level (Hi-Z) ........... >+14 dBu, balanced at 1% THD+N
Max. level (600 ohm) .... >+5.5 dBm, balanced at 1% THD+N
0 dBu = 0.775 Vrms. 0 dBV = 1 Vrms. 0 dBV 2 dBu.