ProSoft Technology WRC-CANX - Manual (Page 12)

Western Reserve Controls WRC-CANX-xx Series 4
PUB 14.1 User’s Manual
8
The WRC-CANX-XX has an 8-pole DIP switch.
• Switch positions 1-4 are used to set the Network A baud rate.
• Switch positions 5-8 are used to set the Network B baud rate.
The baud rates can be set independently, or one side can take its baud rate from the other side
(in the “Remote” setting).
The Autobaud detects from DeviceNet bauds.
For CANopen speeds, select the fix baudrate setting.
When both the CANX units are set to all open switch positions (remote-remote) it scans through
DeviceNet baudrates.
Table 4-1 Baud Rate Settings for Switches
Local Position 1 Position 2 Position 3 Position 4
Baud rate
Remote Position 5 Position 6 Position 7 Position 8
Meaning
125K CLOSED CLOSED CLOSED CLOSED Fixed
250K CLOSED CLOSED CLOSED OPEN Fixed
500K CLOSED CLOSED OPEN CLOSED Fixed
Autobaud CLOSED CLOSED OPEN OPEN
Autobaud for DeviceNet
Bauds (125k,250k,500k)
9.6K CLOSED OPEN CLOSED CLOSED Fixed
10K CLOSED OPEN CLOSED OPEN Fixed
20K CLOSED OPEN OPEN CLOSED Fixed
40K CLOSED OPEN OPEN OPEN Fixed
50K OPEN CLOSED CLOSED CLOSED Fixed
100K OPEN CLOSED CLOSED OPEN Fixed
800K OPEN CLOSED OPEN CLOSED Fixed
1M OPEN CLOSED OPEN OPEN Fixed
Remote OPEN OPEN OPEN OPEN
Takes baud rate from the
opposite end device. If
both sides are remote,
Autobaud from either side.
Autobaud ALL OTHER SWITCH POSITIONS Autobaud
4.3. LED Operation
The WRC-CANX-XX Multiplexer has four (4) LED’s that provide visual status information to the
user about the product and the DeviceNet network. See Figure 4-1, Table 4-2, Table 4-3 and Table 4-4.