ProSoft Technology RLX-IFH9E-A - Manual (Page 4)

Antenna spacing requirements for user safety
It is important to keep the radio's antenna a safe distance from the user. To meet the requirements of FCC part
2.1091 for radio frequency radiation exposure, this radio must be used in such a way as to guarantee at least 20 cm
between the antenna and users. Greater distances are required for high-gain antennas. The FCC requires a
minimum distance of 1 mW *cm2 power density from the user (or 20 cm, whichever is greater).
If a specific application requires proximity of less than 20 cm, the application must be approved through the FCC for
compliance to part 2.1093.
Important Installation Instructions
This equipment is suitable for use in Class I, Division 2, Groups A, B, C and D OR non-hazardous locations only.
WARNING
– EXPLOSION HAZARD – DO NOT DISCONNECT EQUIPMENT UNLESS POWER HAS BEEN
REMOVED OR THE AREA IS KNOWN TO BE NON-HAZARDOUS.
WARNING
– EXPLOSION HAZARD - SUBSTITUTION OF ANY COMPONENTS MAY IMPAIR SUITABILITY FOR
CLASS I, DIVISION 2.
Power must be provided from NEC Class 2 Circuit or a Limited Power Source.
EU Requirements
1. For outdoor use, France has a frequency restriction of 2.4 GHz to 2.454 GHz for an output power greater than 10
mW and below 100 mW.
2. For outdoor use in France, the output power is restricted to 10 mW in the frequency range of 2.454 GHz to 2.4835
GHz.
3. 5.15 GHz to 5.35 GHz is restricted to 200 mW EIRP throughout the European Union.
RadioLinx IFH: FCC Part 15 & Industry Canada Rules
The statements contained in this "Regulatory Approvals" section are required. If the ProSoft Technology, RadioLinx
wireless modem and switches are used as a component of any device, these statements must be a component of
that device’s product documentation.
RadioLinx IFHE: COMPLIANCE STATEMENT
The ProSoft Technology, RadioLinx devices comply with Part 15 of the FCC Rules as well as Industry Canada Rules.
Operation is subject to the following two conditions:

This device may not cause harmful interference, and,
 This device must accept any interference received, including interference that may cause undesired operation.
In Canada, this device is to be operated indoors only and away from windows to provide maximum shielding and to
prevent radio interference to the Canadian licensed service. Equipment (or its transmit antenna) that is installed
outdoors in Canada is subject to licensing.
Note: The ProSoft Technology, RadioLinx module is labeled with an FCC ID number and a Canadian Certification
Number. If this label is not visible when installed in an end-device, the outside of the device MUST also display a
label referring to the enclosed RadioLinx. Use wording on the label similar to the following:
RLX-IFH9E: "Transmitter Module FCC ID: NS906P21, Canada 3143AO6P21"
RLX-IFH24E: "Transmitter Module FCC ID: IC NS907P23, Canada 3143AO7P23"
OR
RLX-IFH9E: "This device contains Transmitter Module FCC ID: NS906P21, Canada 3143AO6P21"
RLX-IFH24E: "This device contains Transmitter Module FCC ID: NS907P23, Canada 3143AO7P23"
WARNING: Changes or modifications to this radio module not expressly approved by its manufacturer, ProSoft
Technology, may void the user
’s authority to operate the equipment.