Yamaha PSR-E353 - Manual (Page 37)

PSR-E353 Owner’s Manual 37
Recording Your Performance
You can record up to 5 of your performances as User Songs (User 1–5: Song numbers
155–159). The recorded User Songs can be played back on the instrument.
You can record your performance to the following two
tracks of a User Song individually or simultaneously.

Track 1:
Your melody performance is recorded to this track.

Track 2:
Your melody performance, or Style playback (Chord
changes and Section changes), is recorded to this
track.

Recording Data Capacity:
A total of approximately 10,000 notes or 5,500 chord
changes can be recorded to the five User Songs.
The operation is convenient for recording a new Song
without having to specify a track.
1
Make the desired settings such as Voice
and Style settings.
If you want to record only the melody perfor-
mance, turn ACMP off (page 22). If you want to
record Style playback as well as melody perfor-
mance, turn ACMP on (page 22).
2
Press the [REC] button to enable the
Record mode.
On the display, the lowest-numbered unrecorded User
Song (“User 1”–“User 5”) appears. If you want to select
another Song, use the [+] and [-] buttons.
To exit from the Record mode, press the [REC]
button again to stop flashing on the display.
3
Play the keyboard to start recording.
If ACMP is turned on, you can independently
record just the rhythm sound of Style playback by
pressing the [START/STOP] button then changing
the Section (page 24).
4
Press the [START/STOP] button to stop
recording.
When using a Style, you can stop recording also
by pressing the [INTRO/ENDING/rit.] button then
waiting until playback ends.
5
To play back the recorded Song, press
the [START/STOP] button.
Track Structure of a Song
Quick Recording
• If all User Songs contain recorded data, “User 1
(Song Number 155)” will automatically be selected. In
this case, since you will record over and erase any
previous data in “User 1,” we recommend that you
save your important data to a computer (see page
43).
• ACMP cannot be turned on or off in this status while you
can select another Style in this status by using the
[STYLE] and Number buttons.
• After Recording stops, a “Writing!” message is shown
on the display for a while. Never attempt to turn the
power off while this is shown in the display. Doing so
can damage the internal memory and result in a loss
of data.
User 1
rEC
001
User Song Number
Flashes
NOTICE
NOTE
36 48
72 60
Split Point ... default setting: 054 (F #2)
Auto Accompani-
ment range
NOTICE