Kurzweil CUP110 - Manual (Page 11)

page 5
Overview
Input/Output Panel
The Input/Output panel is located on the rear of the instrument cabinet.
Audio In and Audio Out
Audio Out (RCA jacks) may be used to connect the Andante CUP110 to external audio equipment, such as an
outboard mixer, powered speakers, or recording device.
Audio In jacks are used to connect the Andante CUP110’s internal speakers to other devices such as
a digital audio player or CD player. Always turn off the CUP110’s power before plugging or unplugging
cables into the Audio In jacks.
The Andante CUP110’s Volume Control does not affect the volume of the sound coming from the Audio
In jacks. Therefore it is best to use a device that has its own output level control and to use that to adjust
the sound volume from the external device.
MIDI In and Out ports
Use the MIDI In and Out ports to connect the Andante CUP110 to other MIDI devices to receive and send
MIDI data.
CC Pedal (Volume/Expression Pedal)
This jack is used to connect a continuous controller pedal for volume and expression control. The CUP110 re-
quires a pedal with a TRS 1/4” connector and 10k linear potentiometer. Most manufacturers EXCEPT Yamaha
and Korg make pedals with the same specifications and should work. Yamaha and Korg pedals typically use
an exponential potentiometer and therefore will not work correctly. The CC-1 pedal is available from Kurzweil.
You can order the CC-1 through your local Kurzweil dealer.
USB
Connect a USB cable to this port to send and receive MIDI or to connect to a computer to apply system
updates.