Kurzweil CUP110 - Manual (Page 8)

page 2
Introduction
Assembly Instructions
In addition to the main piano cabinet, your instrument comes with a stand requiring assembly, using the parts shown
below. Two people may be needed to complete the assembly, as the stand must first rest on the floor and then the
instrument must be securely attached on top of it.
STEP 1:
Place the stand parts on a carpeted floor or blanket. Use the four long bolts to attach the pedal unit to the side pan-
els. Insert the screw caps to cover the bolt ends. Use the four shorter screws to attach the back panel to brackets, as
shown below.
STEP 2:
Move the stand into an upright position and then place the instrument upon it. To avoid possible damage, don’t let the
weight of the body rest on the stand until it is properly aligned and secured with the four screws as shown. Rotate the
pedal adjuster until it comes in firm contact with the floor surface. If the adjuster is not in firm contact with the floor, the
pedal will wobble and cause malfunctions.