Kurzweil CUP110 - Manual (Page 9)

page 3
Introduction
STEP 3:
Insert the pedal cable connector into the pedal jack located on the bottom of the keyboard.
Be sure that the connector is inserted in the correct orientation. Make sure that the cable clamp
fastens to the pedal cable.
STEP 4:
Install the headphone hanger as shown in the picture at right.
Power Connection
A DC power adapter supplies the Andante CUP110’s power.
Connect the power adapter to the DC receptacle on the rear panel of the Andante CUP110. Then connect the power
cord to an AC outlet.
CAUTION:
Use only the DC power adapter supplied with the Andante CUP110. Connecting the wrong DC
power adapter could damage the instrument.
If the power adapter is damaged or lost, contact your Kurzweil dealer to order a replacement .
The AC plug shape will vary
depending on location of use
After the CUP110 is set up, turn the power on. While the unit is performing its power-up routine some of the front panel
buttons will flash. After a couple of seconds, the display will read 1 Grand Piano. The CUP110 is now ready to play.
Use the Quick Start instructions on the following pages for the basic steps to change Voices or play one of the Demo
Songs.
Volume
Before turning on the Andante CUP110, it’s always a good idea to set the volume at its minimum set-
ting (all the way to the left). For a generally comfortable level of volume while playing, set the knob at its
middle position.
The Volume Control is located on the right end of the keyboard. Turn this knob from left to right (clock-
wise) to increase the volume. This adjusts the Andante CUP110 speaker and headphone audio volume.
The Volume control does not affect the volume of the sound coming from external sources through the
Audio In jacks on the rear panel.