Eclipse - Fujitsu Ten AVN6600 - Manual (Page 75)

75
Navigation
gui
dance
Adding a destination
After having set a destination, up to five more destinations can be added.
In the following situations, set an additional destination.
• When setting a transit point between the present location and set destination
• When changing the set destination into a transit point and setting a new destination
Using the same method as setting a destination, touch to add a destination.
(Refer to "One-touch setting" (Page 64), "Set from a registered point" (Page 65) and
"Set using the map retrieval method" (Page 65).)

Touch .

Touch for Destination.

Select the map retrieval method
and display the map on which a
destination is to be set.
• See pages 45 and 61, "How to
retrieve maps" and "Performing
operations on a displayed map".
Add to
Route
Add
• The destination can be set on a map with a scale of 1 mile or greater detail.
• Geographical points on maps representing set destinations are automatically
registered (up to 100 points) and can be used to retrieve a map when setting a
destination. When exceeding 100 points, the oldest entry is deleted every time a
new one is entered. Unnecessary points can be deleted. (
Refer to the Section
"Deleting entries from the destination archive" on page 123.)
• When adding a destination with a transit road (see pages 80 and 81 ) indicated,
that transit road indication may be canceled depending on that geographical
point.
• When 2 or more destinations are set, appears. Reorder
Go to the next page