Extreme Networks 200 Series - Manual (Page 203)

Routing Configuration Example
Summit 200 Series Switch Installation and User Guide 201
Routing Configuration Example
Figure 34 illustrates a switch that has two VLANs defined as follows:
• Finance
— Contains ports 2 and 4.
— IP address 192.207.35.1.
• Personnel
— Contains ports 3 and 5.
— IP address 192.207.36.1.
enable icmp useredirects Enables the modification of route table
information when an ICMP redirect message is
received. This option applies to the switch
when it is not configured for routing. The
default setting is disabled.
enable ip-option loose-source-route Enables the loose source route IP option.
enable ip-option record-route Enables the record route IP option.
enable ip-option record-timestamp Enables the record timestamp IP option.
enable ip-option strict-source-route Enables the strict source route IP option.
enable ip-option use-router-alert Enables the switch to generate the router alert
IP option with routing protocol packets.
enable irdp {vlan <name>} Enables the generation of ICMP router
advertisement messages on one or all VLANs.
The default setting is enabled.
unconfig icmp Resets all ICMP settings to the default values.
unconfig irdp Resets all router advertisement settings to the
default values.
Table 57: ICMP Configuration Commands (continued)
Command Description