Extreme Networks 200 Series - Manual (Page 219)

Configuring RIP
Summit 200 Series Switch Installation and User Guide 217
Configuring RIP
Table 63 describes the commands used to configure RIP.
Table 63: RIP Configuration Commands
Command Description
config rip add vlan [<name> | all] Configures RIP on an IP interface. When an IP
interface is created, per-interface RIP
configuration is disabled by default.
config rip delete vlan [<name> | all] Disables RIP on an IP interface. When RIP is
disabled on the interface, the parameters are
not reset to their defaults.
config rip garbagetime {<seconds>} Configures the RIP garbage time. The timer
granularity is 10 seconds. The default setting is
120 seconds.
config rip routetimeout {<seconds>} Configures the route timeout. The default
setting is 180 seconds.
config rip rxmode [none | v1only | v2only | any]
{vlan <name>} Changes the RIP receive mode for one or all
VLANs. Specify:
• none —Drop all received RIP packets.
• v1only —Accept only RIP v1 format
packets.
• v2only —Accept only RIP v2 format
packets.
• any —Accept both RIP v1 and v2 packets.
If no VLAN is specified, the setting is applied to
all VLANs. The default setting is
any .
config rip txmode [none | v1only | v1comp |
v2only] {vlan <name>} Changes the RIP transmission mode for one or
all VLANs. Specify:
• none —Do not transmit any packets on this
interface.
• v1only —Transmit RIP v1 format packets
to the broadcast address.
• v1comp —Transmit RIP v2 format packets
to the broadcast address.
• v2only —Transmit RIP v2 format packets
to the RIP multicast address.
If no VLAN is specified, the setting is applied to
all VLANs. The default setting is
v2only .
config rip updatetime {<seconds>} Changes the periodic RIP update timer. The
default setting is 30 seconds.
config rip vlan [<name> | all] cost <number> Configures the cost (metric) of the interface.
The default setting is 1.
enable rip Enables RIP. The default setting is disabled.