Extreme Networks 200 Series - Manual (Page 69)

Authenticating Users
Summit 200 Series Switch Installation and User Guide 67
RADIUS Server Configuration Example (Merit)
Many implementations of RADIUS server use the publicly available Merit © AAA server application,
available on the World Wide Web at:
http://www.merit.edu/aaa
Included below are excerpts from relevant portions of a sample Merit RADIUS server implementation.
The example shows excerpts from the client and user configuration files. The client configuration file
(
ClientCfg.txt ) defines the authorized source machine, source name, and access level. The user
configuration file ( users ) defines username, password, and service type information.
ClientCfg.txt
#Client Name Key [type] [version] [prefix]
#---------------- --------------- -------------- --------- --------
#10.1.2.3:256 test type = nas v2 pfx
#pm1 %^$%#*(&!(*&)+ type=nas pm1.
#pm2 :-):-(;^):-}! type nas pm2.
#merit.edu/homeless hmoemreilte.ses
#homeless testing type proxy v1
#xyz.merit.edu moretesting type=Ascend:NAS v1
#anyoldthing:1234 whoknows? type=NAS+RAD_RFC+ACCT_RFC
10.202.1.3 andrew-linux type=nas
10.203.1.41 eric type=nas
10.203.1.42 eric type=nas
10.0.52.14 samf type=nas
users
user Password = ""
Filter-Id = "unlim"
admin Password = "", Service-Type = Administrative
Filter-Id = "unlim"
eric Password = "", Service-Type = Administrative
Filter-Id = "unlim"
albert Password = "password", Service-Type = Administrative
Filter-Id = "unlim"
samuel Password = "password", Service-Type = Administrative
Filter-Id = "unlim"
RADIUS Per-Command Configuration Example
Building on this example configuration, you can use RADIUS to perform per-command authentication
to differentiate user capabilities. To do so, use the Extreme-modified RADIUS Merit software that is
available from the Extreme Networks web server at
http://www.extremenetworks.com/extreme/support/otherapps.htm or by contacting Extreme
Networks technical support. The software is available in compiled format for Solaris
™ or Linux ™
operating systems, as well as in source code format. For all clients that use RADIUS per-command
authentication, you must add the following type to the client file:
type:extreme:nas + RAD_RFC + ACCT_RFC