Planar Systems LO552 55" Full HD Transparent OLED Commercial Monitor - Manual (Page 12)

Planar LookThru Transparent OLED Display User Manual
020-1380-00E
Page | 12
Tour of the Planar LookThru Transparent OLED Product Family
recommended to be used for any installation, 20mm max thread penetration. The Display
Chassis is the part of the display to use as a primary handhold during transport and
mounting.
There are five secondary M6 mounting points on the underside of the electronic box,
20mm max thread penetration. These should only be used together with the primary
mounting points on the Display Chassis, but never by themselves. A counter weight is
attached to the underside of the electronic box in the Planar LookThru. The counter
weight also serves to create an acceptable open space for ventilation on the underside of
the display. Like the leveling feet, it should be removed for a fixed mount installation, but
provisions must be made for the proper 5 mm inch spacing.
Note that the corners of the Display Chassis and the right side (viewed from the front) of
the electronic box are chamfered at a 45
º angle, allowing a corner or right-angle
installation of Planar LookThru displays. This is a feature found in all the Planar LookThru
family of displays. The bottom view of a Planar LookThru in the figure below illustrates
the corner chamfers. The leveling feet and counterweight are also shown.
The backside of the electronic box also contains the controlling I/O for the display. This is
shown in the figure below. The power switch and power cord receptacle are centered on
the backside.
The keypad is described in detail in the “OSD Keypad” section on page 23. There are
four HDMI connectors consisting of two HDMI 2.0 compliant and two HDMI 1.4 compliant
inputs. Additionally, there is a DisplayPort 1.2 input and a corresponding DisplayPort
output. The RS-232 and LAN connectors are found on the right side of the electronic box
along with the jack for the remote sensor as well as USB-A and USB-B ports.