Planar Systems LO552 55" Full HD Transparent OLED Commercial Monitor - Manual (Page 20)

Planar LookThru Transparent OLED Display User Manual
020-1380-00E
Page | 20
Unpacking and Installing the Display
7. Environmental Considerations

The Planar LookThru is intended for indoor use only.

Displays should only be installed in an environment where the temperature and
humidity are kept within the proper use range. See the Environmental Specifications
on page 65.

Planar LookThru displays should not be operated on a carpet that can stifle
ventilation through the perforations in the underside of the electronic box.

Planar LookThru displays are not designed to be sunlight readable.

Do not locate the displays in direct sunlight or where the Display Glass will be
exposed to ultraviolet (UV) light.

The electronic box should not be located near heat sources or in an environment
where there is less than 0.47 inches (12 mm) of free space on all sides. Note that the
Display Glass and the Display Chassis do not rise in temperature much above
ambient during operation.

For best use of the display transparency, make certain there is adequate illumination
in the space behind the screen so that items of interest can be viewed optimally
through the display. We recommend experimenting with the level and orientation of
the illumination.
8. Installation Disclaimer
Proper installation of the display is the responsibility of the end customer. Failure to
follow the safety and installation instructions in this manual
, Content Developer’s Guide
or Fabricator’s Guide, or any installation of the display in a manner not described in this
manual
, Content Developer’s Guide or Fabricator’s Guide, may result in damage to the
display or unsafe conditions, which will not be covered by the product warranty.
9. Requirements for All Installations
Make sure the surface or structure where the display is to be mounted is capable of
supporting the weight of the display or displays to be used.
Consult the “Specifications”
section on page 65 for weights and measures.
If the display is to be attached to a surface or structure, use the five M6 mounting points
in the Display Chassis as the primary attachment point. The mounting holes in the
electronic box employed can provide supplementary support but should not be used for
mounting by themselves. 20mm max thread penetration for primary and secondary
mounting holes. No fewer than three of primary mounting holes should be used in any
installation.
Make sure the Display Glass maintains a neutral position and is not loaded in any way.
The front Display Glass surfaces should be mounted straight and plumb, i.e.
perpendicular to the horizontal in all axes.