Enterasys Networks 7S4280-19-SYS - Manual (Page 36)

Setting Up the Enterasys Matrix N1 Chassis
3-2 Enterasys Matrix N1 Chassis Setup
4. Inspect the Enterasys Matrix N1 Chassis for any signs of physical damage. Contact
Enterasys Networks if it is damaged. Refer to
“Getting Help ” on page xviii for details.
Setting Up the Enterasys Matrix N1 Chassis
The following sections describe the procedures that must be followed to complete the installation
of the Enterasys Matrix N1 Chassis.
Order of Installation
Once a suitable site has been chosen, the Enterasys Matrix N1 Chassis can be installed as a
freestanding or rackmounted unit.
It is recommended that the Enterasys Matrix N1 Chassis installation proceed in the following
order:
1. Install the rubber feet (for standalone installation). For details, refer to “ Installing the Rubber
Feet ” on page 3.
2. Mount the chassis to a 48.26‐centimeter (19‐inch) rack or other secure location. For details,
refer to “
Installing the Chassis into a Rack ” on page 3.
3. Attach the Electrostatic Discharge wrist strap. For details, refer to “ Attaching the Electrostatic
Discharge Wrist Strap ” on page 4.
If you are installing the Enterasys Matrix N1 Chassis as a freestanding device, start with
“
Installing the Rubber Feet ” on page 3. To install the chassis in a rack, rubber feet are not needed.
Installing the Chassis on a Flat Surface
Table 3-1 Contents of the 2S4082-25-SYS and 7S4280-19-SYS 7C111 Carton
Item Quantity
2S4082-25-SYS or 7S4280-19-SYS Standalone Series 7C111 1
2S4082-25 or 7S4280-19 NAC Controller PEP 1
Rubber Feet 4 (self-adhesive)
Power Cords 2
ESD Wrist Strap 1
Manual URL Location Card 1
Patents Sheet 1
Hardware Installation Guide (this manual) 1
Note: Before installing the rubber feet, place the chassis on its back on a sturdy flat surface to have
access to the bottom of the chassis.
Caution: Read Chapter 2 before completing the following procedure to ensure that all installation
guidelines are met.
Precaución: Antes de llevar a cabo el siguiente procedimiento, lea
Chapter 2 para y asegúrese de
cumplir con todos los requisitos de instalación.