EXP Computer PathBuilder S200 - Manual (Page 122)

118 Bridging
Dual LAN Ethernet
Routing In IP/IPX or AppleTalk routing environments, do not connect both Ethernet LAN
ports to the same Ethernet segment with identical routing decision values. This is not
supported.
How to Configure
Dual Ethernet LAN Follow these steps to configure a node for Multiple Ethernet LAN.
Step Action Result/Description
1 Make a local CTP connection to a
PathBuilder S24x, 26x, and 27x
switch. The CTP is physically connected to
the device you are configuring.
2 Select Configure -> Port from the
CTP Main menu. The Port record appears.
3 Configure the Port record as you
normally do for an Ethernet LAN
connection. Two new parameters, Bridge Link
Number and Router Interface,
appear in the record.
4 At the Bridge Link Number:
parameter, type in a number 1-4 to
identify the bridge link, and press
Return.
Note
The default value for this
parameter is 1.
This matches this port configuration
to a specific bridge link number
within the bridging configuration. If
the bridge link you select is already
used, a warning message appears,
but your input is retained in the
CMEM.
5 At the Router Interface Number:
parameter, type in a number 1-4 to
identity the router interface.
Note
The default value for this
parameter is 1.
This matches this port configuration
to a router link number within the
router configuration. If the router
interface number you select is
already used, a warning message
appears, but your input is retained
in the CMEM.
6 Type; and press Return to save the
record. This saves the record.
7 Perform a Node boot from the Boot
menu. This implements your changes, but
if you want the new bridge link to
be active, you must configure the
Bridge Link record under the
Configure Bridge menu. Go to the
following step. By default, the
bridge link is not activated until you
activate it.
8 Select Configure Bridge ->
Bridge Link Parameters from
the CTP Main menu, to activate the
bridge link.
The Bridge Link Parameters menu
appears.
9 Type ; and press Return. The record is saved.