Wifi network – Kiloview 3G-SDI to H.264 Wireless Video Encoder User Manual
Page 13
Version 1.1 © Changsha KILOVIEW Electronics CO.,LTD. All rights reserved
G1-s VideoEncoders · User Manual
9
After Ethernet is configured correctly, you can see that the connection status is “Internet reachable” and
the Internet connection is the default Ethernet port on the Information Board.
5.3.2
WIFI network
WIFI configuration has two modes, which can realize two functions. "Default WIFI" is used as ordinary
terminal, connect router WIFI signal, use WIFI to transmit video; "WIFI1" is as AP hot spot to be
connected by other devices, default hot spot name is "CAST_AP" and the hot spot password is
"12345678". You can use a mobile phone or laptop to connect to this hot spot to log in and manage the
encoder. After connecting to this hot spot, you can log in to the encoder's web page by typing
"192.168.250.254" in the browser of your mobile phone or laptop. As shown in the figure below, click
“Set as Shared Hot spot”
of WIFI 1 to customize the shared hot spot name and shared password. You
can select the WIFI channel and the network card to be shared.
For normal use, just click "Default WIFI" option to enter the interface that connects to WIFI.
Click
“
WIFI scanning list
”
to connect, usually you need to enter a WIFI password to connect
successfully. For some WIFI that hides the SSID, you can also connect a hidden hot spot by manual. The
WIFI that has been successfully connected, the encoder will save this record. By default, this WIFI will be
automatically connected next time. You can also select this saved WIFI hot spot to disconnect or delete
the WIFI.