Enterasys Networks 2H252-25R - Manual (Page 32)

Installing the Device
3-6 Installation
Figure 3-2 Attaching the Strain-Relief Bracket
Rack Mounting the 2H252-25R
Proceed as follows to install the 2H252-25R into a 19-inch rack:
1. There are several mounting holes in the rackmount brackets and the bottom of the chassis so that
each mounting bracket may be adjusted forward or backward to mount the device further into,
or out of the rack, depending on the installation requirements. Position the rackmount brackets
over the appropriate holes.
2. Locate the four 6-32 x 1/4-inch flathead screws in the rackmount kit. Use these screws to attach
the rackmount brackets to the bottom of the 2H252-25R as shown in Figure 3-3 .
CAUTION: Do not attempt to attach the rackmount brackets with screws other than the
6-32 x 1/4-inch flathead screws shipped with the 2H252-25R. Use of longer screws may
damage the unit.
Strain-Relief
Bracket
Strain-Relief
Bracket Screws
4005_00_03
RESET
COM
PWR CPU
2H252-25R
2X 4X 6X 8X 10X 12X 14X 16X 18X 20X 22X 24X
1
2 3
4 5
6 7
8 9
10
15
16 21
22 23
24 11
12 19
20 17
18 13
14 LED MODE
RX-TX
DPX-SPD
FAST ETHERNET WORKGROUP SWITCH