Enterasys Networks 2H252-25R - Manual (Page 40)

Using LANVIEW
4-2 Troubleshooting
Figure 4-1 LANVIEW LEDs
The LED MODE switch is located on the front panel of the 2H252-25R as shown in Figure 4-1 .
This switch enables the user to change the function of the port LEDs. When the LED MODE
switch is moved to the left, the LEDs indicate the receive (RX) and transmit (TX) status of the
respective fixed ports (ports 1 through 24). When the LED MODE switch is moved to the right, the
port LEDs indicate whether the respective ports are operating in the standard or full duplex mode
(FDX) and if their operating speed (SPD) is 10 or 100 Mbps.
NOTE: The LED mode switch does not change the function of any LEDs on an installed
HSIM or VHSIM.
Full Duplex Status
Speed Status
LED
MODE
RX-TX
DPX-SPD
Receive (RX)
Transmit (TX)
DPX-SPD
RX-TX
LED
MODE
4005_00_09
CPU PWR
RESET
COM
PWR
CPU
2H252-25R
2X 4X 6X 8X 10X 12X 14X 16X 18X 20X 22X 24X
FAST ETHERNET WORKGROUP SWITCH
1
2
3
4
5
6
7
8
9
10
15
16
21
22
23
24
11
12
19
20
17
18
13
14
LED
MODE
RX-TX
DPX-SPD
A
A
B
B
LED functions when LED MODE switch is in the RX-TX position. This is the
default switch setting.
LED functions when LED MODE switch is in the DPX-SPD position.