Enterasys Networks 2H252-25R - Manual (Page 56)

Removing the Chassis Cover
B-4 Optional Installations and Mode Switch Bank Settings
3. Use a Phillips screwdriver to remove the four screws attaching the cover to the chassis. (See
Figure B-1 .)
Figure B-1 Removing the Chassis Cover
4. Remove the cover by sliding it back until it clears the front of the chassis and then lifting it
straight up and off the chassis.
To reinstall the chassis cover, perform the removal procedures in reverse.
2504-30
Note: If the device was rack mounted, the four screws fastening the cover to
the front panel are removed and installed along with the rackmount brackets.
Chassis
Front Panel
Screws (4)
Chassis Cover