Enviro DV42DX - Manual (Page 11)

Maintenance And Service
b
uRneR anD
F
an
R
emovaL
:
1. Remove brick liners, see steps 1 to 4 in S econdary i nStallation - b rick l iner r eMoval .
2. The control panel is held in place with a T-20 screw on each end of the panel. Remove the two (2)
screws and the control panel.
3. Undo the four (4) screws holding the burner down, the andirons and grate can be removed from the
burner or left on. Pull the burner to the left approximately 1” (25 mm), this is done in order to slide
the venturi out of the venturi box. Remove the burner from the firebox.
4. Four (4) screws along the top of the air deflector hold it in place, remove the screws and the
deflector.
5. Remove the ten (10) screws around the perimeter that hold the valve tray in place and remove the
valve tray.
6. On either side of the fan there is a screw fastening the fan mount to the firebox, remove the screws
to remove the fan.
Re-install everything by following steps 1 to 6 in reverse order.
Control Panel
Andirons and Grate
Burner
Air Deflector
Valve Tray
Fan
Figure 9: Removal of DV42DX Burner and Fan.
11