ENG Electric UNIDISK SC PLAYER - Manual (Page 17)

Setup Menus
Surround
Default setting: Large
Choose the option that best suits the speakers in your
system:
Large surround speakers (full-range frequency
response), set to Large.
Small surround speakers (limited bass response),
set to Small.
No surround speaker, set to Off.
Subwoofer
Default setting: On
If you have connected a subwoofer, set to On.
If you have not connected a subwoofer, set to Off.
The next menus allow speaker distances to be described to
the UNIDISK SC so that the unit can add time delays to
certain speakers. This ensures the sound from all the
speakers reaches your seating position at the same time.
Front Posn. (position)
Default setting: 1.5 m/5 ft
Calculate the approximate distance between your
seating position and your front speakers.
Highlight the 1.5 m/5 ft option then use the key on
the handset or front panel to increase the distance
shown (up to 9.2 m/30 ft).
Select the appropriate distance by pressing ‘enter’ on the handset or front panel.
Centre Posn. (position)
Default setting: 1.5 m/5 ft
Calculate the approximate distance between your
seating position and your centre speaker.
Highlight the 1.5 m/5 ft option then use the key on
the handset or front panel to increase the distance
shown (up to 9.2 m/30 ft).
Select the appropriate distance by pressing ‘enter’ on the handset or front panel.
Surround Posn. (position)
Default setting: 1.5 m/5 ft
Calculate the approximate distance between your
seating position and your surround speakers.
Highlight the 1.5 m/5 ft option. Use the key on the
handset or front panel to increase the distance shown
(up to 9.2 m/30 ft).
Select the appropriate distance by pressing ‘enter’ on the handset or front panel.
Note:
It is not necessary to set the position for a subwoofer.
Test Tone
For maximum enjoyment of your UNIDISK SC, it is
important to ensure that the volume level reaching your
seating position is the same for each speaker in your
system. Speaker volume trim is adjusted using the unit’s
test tone feature.
When set to On, a tone signal is sent to all speakers
(except a subwoofer*) starting with the front left and
moving in a clockwise direction.
To perform speaker volume trim:
● Set Test Tone to On. The test tone display appears on the UNIDISK SC’s front
panel.
● Wait for the test tone to reach the speaker you wish to adjust (your display device
and the front panel indicate which speaker the tone is emitting from).
● Repeatedly press or hold VOL - / + on the handset to trim the volume as
required.** Volume trim range is –10 to +10 (in 0.5 steps) with neutral trim being 0.
A few seconds after the VOL - / + key has been released, the test tone will continue its
clockwise direction.
To exit speaker volume trim:
● Set Test Tone to Off.
* For subwoofer adjustment– see Subwoofer trim in Pre-amplifier chapter.
**You can do this by ear or by using a Sound Pressure Level meter.
11
English
UNIDISK SC PLAYER
Owner’s Manual
Uni SC ENG part 1 for japan 9/28/05 12:41 PM Page 17