ENG Electric UNIDISK SC PLAYER - Manual (Page 21)

Setup Menus English
UNIDISK SC PLAYER
Owner’s Manual 15
Dolby PL II Mode (Analogue outputs only)
Default setting: Movie
This menu is suitable for use if your UNIDISK SC is
connected to front, plus centre and/or surround
speakers.
Dolby Pro Logic II creates five output channels from
any internal or auxiliary two-channel source, such as
an audio CD, stereo tuner signal or set-top box audio
signal. This is achieved using an advanced, surround
decoder that extracts the spatial qualities of the
original recording/signal without adding any new
sounds. The UNIDISK SC offers four modes of Pro
Logic II operation.
Dolby PL
This mode recreates the surround processing offered by original Dolby Pro Logic. The
Dolby PL setting is suitable if the source material is not of the best quality (for
example, a worn VCR tape).
Music
As its name suggests, this mode is recommended when listening to music. If you
select Music mode you can adjust certain Dolby Pro Logic II parameters in the Dolby
PL II Cntl menu (see opposite).
Movie
This mode is recommended for when watching DVD-Videos.
Matrix
Matrix mode can be used to enhance mono signals (e.g. AM radio broadcasts) by
making them seem “larger”.
Dolby PL II Cntl (Control)
If you have selected Music in the Dolby PL II Mode menu, then you are able to enter the
Pro Logic II Cntl menus. Highlighting Dolby PL II Cntl and pressing ‘enter’ reveals the
first Dolby PL II Cntl screen.
Dimension
Default setting: 0
The Dimension control allows you to shift the balance
between the front and surround speakers. Positive
values move the sound towards the front, negative
values towards the surrounds. If a recording is too
spacious or strong from the surround speakers it can be
shifted “forward” to get a better balance. A stereo
recording can be shifted “backward” to make the sound
more enveloping.
Panorama
Default setting: Off
If set to On the Panorama control extends the audio
signal from the front left and right speakers, to include
the surround left and right speakers. This will add a
“wraparound” effect to the sound.
Centre Width
Default setting: 0
This control allows adjustment of the audio signal
between the centre speaker and front left and right
speakers.
If set to 0, all of the audio signal for the centre channel
is sent to the centre speaker.
If set between 1 and 6, a lesser to greater portion of the
centre channel signal is also sent to the left and right
front speakers.
If set to 7, all of the centre channel signal is split evenly between the front left and right
speakers.
To exit Dolby PL II Cntl:
● Select Audio Setup and press ‘enter’.
Uni SC ENG part 1 for japan 9/28/05 12:41 PM Page 21