ENG Electric UNIDISK SC PLAYER - Manual (Page 19)

Setup Menus
EDID
(Extended Display Identification Data)
Default setting: Enabled
Identifies the picture resolutions that are supported
by the display device. Data supplied by the display
device allows the UNIDISK SC to automatically output
the best resolution that the device supports.
It has however been known for some display devices
to provide erroneous data or no data and this can
cause picture problems. In such cases this option
should be set to D
Diis sa ab blle ed d.
If set to D Diis sa ab blle ed d, the resolution will be determined
by the Video Standard that is selected in the General
Setup menu.
13
English
UNIDISK SC PLAYER
Owner’s Manual
Video Source Setup
Default setting: Off
The following menus allow you to configure the
UNIDISK SC’s video output for any of the auxiliary
source inputs: DIG 1 - 4 Video, AUX 1 - 2 Video and
MAIN Video (for use in a KNEKT system).
● Set to Off if the auxiliary source is audio only
or if the auxiliary source carries a video signal
that you do not want to pass through the
UNIDISK SC.
● Set to Internal if you want the UNIDISK SC to
output its internal video signal (the Linn name
screen) when this auxiliary source is selected.
● Set to Pass-through if you want to route the auxiliary source’s video signal
through the UNIDISK SC (for Pass-through to work, input and output connectors
must match).
Example:
If you have a set-top box’s S-video output connected to the UNIDISK SC’s S-VIDEO IN,
and the set-top box’s digital optical output connected to the UNIDISK SC’s DIG 3 input,
you would want to set DIG 3 Video to Pass-through.
Uni SC ENG part 1 for japan 9/28/05 12:41 PM Page 19