Ericsson BusinessPhone - Manual (Page 45)

$GGLQJ D 1HZ 'LVSOD\ 8QLW
BusinessPhone Call Centre Supervisor - Standard
Installation Guide
EN/LZT BS 102 063/S R2B
45
$GGLQJ D 1HZ 'LVSOD\ 8QLW
The parameters needed to set up a Display Unit are entered via the Add a New
Display Unit Dialog. The Dialog is accessed from the Display Unit Connection
Dialog by clicking the New button or by pressing Alt + N.
New Display Unit are added by setting the following parameters:
• Display Unit Name
• Display Unit Type
• Device (The device that the Display Unit is connected to)
• Baud Rate
• Display Unit Address
After all parameters have been correctly set the connection is added by clicking
OK
'LVSOD\ 8QLW 1DPH
Each Display Unit must be assigned a unique name.
When adding a new Display Unit a warning will be displayed if you enter a name
that is already in use. Once assigned a Display Unit name cannot be edited, if a
new name is required then the original Display Unit connection should be delet-
ed and a new connection with the new name established.