Basic operations – EnGenius Technologies SN-920 User Manual

Page 11

Advertising
background image

~ 15~

Your EnGenius phone system uses rechargeable Nickel Metal
Hydride (Ni-MH) battery packs. Each battery provides up to thr e
hours of talk-time, based on range, terrain and environmental
conditions, or up to 40 hours of standby time. These high
performance battery packs have an average life span of about
300 charges (a charge is defined as going from empty to fully
charged). Additional or replacement new SN-920 ULTRA battery
packs are available as part number: SN-920 ULTRA-BA.

Danger of explosion if battery is incorrectly

replaced. Replace only with the same or equivalent type
recommended by the manufacturer. Dispose of used
batteries according to the manufacturer's instructions.

Do not open the plastic battery pack encasing.

Low Battery Indicator

*
*
*
*

Charge the batteries when one of the following happens:

Phone beeps twice every two seconds
Battery icon is empty
Phone does not respond when a key is pressed
LCD and backlighting become dim

Battery Replacement

CAUTION!

CAUTION!

e

~ 16~

IDLE MODE

TALK MODE

REGISTRATION MODE

Operation Modes

Base Operation Modes

Handset Operation Modes

Both the base unit and handset have levels of operation at which
time only certain procedures or functions can be performed.
These levels or modes of operation will be referred to throughout
this manual and vary from base unit to handset.

The base unit operates in three different modes: IDLE, TALK, and
REGISTRATION.

- this is the default mode. The intercom and volume

keys are active in IDLE mode. The POWER LED is red.

- the base operates in this mode during an

incoming or outgoing intercom call and an incoming or outgoing
phone call. Volume key is active in TALK mode. POWER, IN USE
and INTERCOM (during an intercom call) LEDs are red.

- the base enters this mode by

simultaneously holding down the intercom and volume keys for
three seconds. There are no active base unit keys once this mode
has been entered. The IN USE and POWER LEDs are illuminated.
The IN USE LED will come on and stay active for approximately
30 seconds and then turn off.

The handset operates in one of five different modes: IDLE,
MENU, TALK, REGISTRATION and CRADLE.

BASIC OPERATIONS

Advertising