EnGenius Technologies SN-920 - Manual (Page 38)

whip x 6
EnGenius Optional Outdoor Antenna
lnstallation lnstructions TM
For safety and optimum performance, be sure to read these
instructions carefully.
Order lnformation
Please order the EnGenius SN-900 Ultre Outdoor Antenna and/or
cable.
Warning
For your safety, keep the antenna away from electric power lines to
avoid electric shock.
TM
For FCC compliance, the outdoor antenna must not be located
within 8 inches (20cm) of any person.
Site Selection
The higher the antenna is installed, the better the communication
will be. lf you can install the antenna higher than surrounding
obstructions, the communication range will be better.
The antenna must be on the roof and maintain a three meter
(10 feet) clearance in all directions to meet RF safety requirements.
Antenna lnstallation
1. Find a mast (metal pole) that is longer than five meters and 25 to
50mm (1"to 1.9") in diameter.
2. Assemble the antenna body and six whips.
3. Connect brackets to guide
pipe, sliding the brackets on
from the bottom.
4. Fit the guide pipe and
bracket on mast firmly.
5. Thread the coaxial cable
through the guide pipe and
connect one end of the
coaxial cable to the antenna.
6. Connect the other end of
the coaxial cable to the base
station.
Note:Use only EnGenius antenna and cable. The base
station antenna connector has reverse thead that
only works with cables supplied by EnGenius.
Over 3 M (correct)
Over 3 M
(correct)
Over 3 M
(correct)
Less than 3 M
(incorrect)
Less than 3 M
(incorrect)
Bracket
Guide pipe
Mast
Antenna