EnGenius Technologies SN-920 - Manual (Page 16)

~ 26~
Voice Volume
Placing a Call On-Hold
Adjusting the volume on the handset can be done only during a
call or when in the TALK Mode.
* When in the TALK Mode, the volume control button on the left
side of the handset can be used to adjust the volume to 6
different levels.
* Volume level 3 is set as default.
* The top button increases volume and the lower button
decreases volume.
* The screen during volume adjustment
displays the following:
1. When a call is in progress it can be
put on hold by pressing the LEFT
SOFT FUNCTION key which selects
the HOLD option:
The display will then show:
2. To bring the call back on line, press
the LEFT SOFT FUNCTION key again.
The display will return to this screen:
The handset will double beep three times every 30
seconds when a call is on hold as a reminder that you
REDIAL MEMORY
VOLUME: 5
HOLD
00:00:00
Call hold L1
UNHOLD MENU
VOLUME: 5
HOLD MUTE
~ 25~
: The first handset to answer a call will connect to
the base unit and will operate in TALK mode. O ther
registered handsets will be locked out of the call. However
they will still be able to participate in handset to handset
calls or receive the call if transferred.
NOTE
Caller ID service must be ordered from your local phone
company for these screen displays to function. Services may
vary in your area.
**
Handset in Charging Cradle
Handset not in Charging Cradle
Pick-up handset from charging cradle to answer the call.
Press "TALK" or any key (except END) to accept the
incoming call.