Energy Tech Laboratories 7900CTP User Manual
Page 10
10
| Setting Up the PCU
4.
Make sure the trays are fully seated in the slots. You can check this by looking through the slot
openings to see if the trays are level with the belt inside the PCU.
Note:
Both trays should be at a slight incline towards the PCU.
5.
To make adjustments if necessary, use the plastic nuts located underneath the tray to create more or
less incline. Turn the nuts counterclockwise to increase the tray angle or clockwise to decrease it.
6.
Plug the PCU into an outlet compatible with the 220/240 V, 20A single phase plug.
7.
If you prefer to run a plate from the rear to the front, you can reverse the direction of the feed by
pressing the feed direction switch on the side of the PCU.
Note:
It is safe to press the feed direction switch even while the belt is moving.
Plastic nuts
Tray
Counterclockwise
raises the tray
Clockwise lowers
the tray
Feed direction
switch