Energy Tech Laboratories 7900CTP - Manual (Page 13)

Installing the Plate Guide on the Printer | 13
Caution:
The transport belt should be kept moving when the heater is turned on. This reduces the surface temperature of
of the transport belt and improves belt life.
Always turn off the Heater switch on the control panel before you turn off the main power switch. Let the PCU
cool to 100 °C or less, according to the current temperature indicator, before turning off the power switch.
WARNING:
Aluminum plates are hot when they exit the PCU. Let the plate cool before removing it from the tray to avoid
burns. Use of gloves is recommended to avoid injury.
Installing the Plate Guide on the Printer
To assure proper registration when printing on Epson DirectPlate Aluminum plates, you need to install
the plate guide on the printer.
1. Open the roll paper cover on the printer.
2. Remove the roll paper if installed, to have room to attach the screws on the plate guide. See the
Epson Stylus Pro 7900/9900 Printer Guide for more information.
3. Slide the plate guide onto the right side of the roll paper cover, aligning it snugly with the black edge
of the roll paper cover.