Energy Tech Laboratories 7900CTP User Manual
Page 20
20
| Loading a Plate in the Printer
2.
Make sure the printer is turned on, the P power light is not flashing, and the roll paper cover is firmly
closed.
3.
Press the l Paper Source button until the
Sheet icon appears on the LCD display.
4.
Press the
Paper release (ePlaten) button.
5.
Set the printer to the highest paper suction setting. This will help load the plate. To do that, press u to
increase the suction.
6.
Insert the plate (with light gray, coated side face up) into the paper slot short-edge first and slide it
against the two alignment points along the top and bottom of the plate guide. Lower the plate into the
printer until you feel the suction holding the plate.
7.
While gently holding the plate against the guide, press the
Paper release (ePlaten) button again to
close the paper release.
The
PRESS PAUSE
message appears on the printer’s LCD screen when the printer detects the plate
and the paper release has closed.
Paper release
(ePlaten) button
Top alignment
point
Bottom
alignment point