Energy Tech Laboratories 7900CTP - Manual (Page 17)

Installing the Plate Guide on the Printer | 17
Applying the Guide Strip
After the plate guide is aligned correctly, attach the Teflon guide strip to the printer to prevent plates from
catching under the plate guide.
1. Remove the adhesive backing from the strip.
2. Align the strip as shown against the plate guide, and apply it from just above the top of the guide to
the bottom edge of the roll paper cover.
Note:
You should cover the markings on the aluminum roll paper cover with clear packing tape. This is recommended
because long-term use of the plates may wear the markings off.
Teflon strip