Energy Tech Laboratories 7900CTP - Manual (Page 9)

Setting Up the PCU | 9
Setting Up the PCU
You should allow an area of 50 × 33 inches (127 cm × 84 cm) for the PCU. The PCU has an L6-20P plug
and requires a 220 V L6-20 electrical outlet.
Caution:
The electrical outlet must be rated for 220/240 V AC (with an acceptable range of 208 to 240 V).
1. Place the PCU on a level, stable surface.
WARNING:
The PCU contains a heater and rises to high temperatures. Aluminum plates are very hot when they come
out. Do not touch the plates or slots when hot to avoid burns. Use of gloves is recommended. Make sure the
plates are dry when putting them through the PCU. Do not open the PCU because of electric shock danger.
2. Attach the input tray (the smaller one) to the unit by inserting the tab into the front slot of the PCU.
Press the tray down to make sure the tab is completely locked into the PCU.
3. Attach the output tray (the larger one) to the slot at the rear of the PCU by inserting the tab and
pressing it down in the same way.
Control panel
Input tray
Output tray