EverFocus EDR410H - Manual (Page 55)

Default is set to none. To change this, simply use the Jog Dial
DVR. Press the Enter key to make your selection.
¾ RS232 Data Bit: This field is the data bit at which you will be
transferring. There are two settings for this option: 8 or 7. The default is
set to 8. To change this, simply use the Jog Dial on the DVR. Press the
Enter key to make your selection.
RS485:
¾ RS485 Baud Rate: This field is to set the speed at which is used to
transmit instruction or information through the RS485 port on the DVR.
There are six different speeds, 1200 BPS, 2400 BPS, 4800 BPS, 9600
19200 BPS, and 3840 BPS. The default setting from the factory is 9600
BPS. To change this, simply use the Jog Dial on the DVR. Press the
Enter key to make your selection.
¾ RS485 Stop Bit: This field is to set the stop bit for the RS485
on the
BPS,
connection. There are t stop bits, 1 or 2. The default in the
mply use the Jog Dial on the DVR.
se between None, Odd, or Even parity levels.
Default is set to none. To change th
¾ RS485 Data Bit: This field is the data bit at which you will be
to make your selection.
¾ RS2 vice its own ID
code if more than one unit is used through the RS232/RS485 connection.
Dial on the DVR. Press the Enter key
to make your selection.
¾
/2250.
wo different
DVR is set to 1. To change this, si
Press the Enter key to make your selection.
¾ RS485 Parity: This field is to select the parity level at which you will be
connected. You can choo
is, simply use the Jog Dial on the
DVR. Press the Enter key to make your selection.
transferring. There are two settings for this option: 8 or 7. The default is
set to 8. To change this, simply use the Jog Dial on the DVR. Press the
Enter key
32/RS485 ID: This entry is used to assign each de
There are two ID codes for the DVR: 001-255. The default is set to 001.
To change this, simply use the Jog
PTZ PROTOCOL: Select PTZ protocol from EVERFOCUS,
PELCO-D, PELCO-P and ED2200
47