5setting the preliminary control settings – Eton S350 User Manual

Page 6

Advertising
background image

S 3 5 0

O P E R A T I O N M A N U A L

11

it off automatically (to minimize excess bat-

tery drain). To change this automatic turn-off

time from 90 minutes to a shorter time, see

the section titled USING THE SLEEP TIMER.

2. WITHOUT TIMER: A long press of approxi-

mately 3 seconds of the ‘POWER & SLEEP’

button turns the radio on without engaging

the automatic 90-minute timer feature, caus-

ing the radio to play indefinitely when using

the AC adaptor, and turning off only when the

batteries drain or the radio is turned off.

There are two ways to turn the radio on, with the

90-minute timer feature or without the 90-minute

timer. To turn it off at any time, press the ‘POWER

& SLEEP’ button.

NOTE: When SLEEP Times is off, the clock

always shows in the display.

1. WITH TIMER: A quick, short press of the

‘POWER & SLEEP’ button turns the radio on.

‘90’ shows in the display for about three sec-

onds, then the radio’s normal frequency dis-

play shows. Turning it on this way causes it

play for 90 minutes, after which its timer turns

6

TURNING THE RADIO ON AND OFF

7

SIGNAL STRENGTH INDICATOR

When you are listening to stations, the signal

strength meter, in the upper right area of the dis-

play, will show the strength level of reception.

10

5

SETTING THE PRELIMINARY CONTROL SETTINGS

Use these controls as initial guidelines. As you get

to know the radio, you will develop your own

‘favorite’ settings.

• Turn the VOLUME control down to no

greater than 3 so that the radio does not play

loudly when first turned on.

• Turn the AM/SW RF GAIN control to the

10 position.

• Turn the BASS-TONE-TREBLE controls into

the 5 position.

• Turn the SW LPF switch to the OFF position

(right side of the radio).

• Turn the STEREO MONO switch to the

MONO position.

Advertising