Eicon Networks 800-241 - Manual (Page 17)

Getting Started 17
North American users only. If you are using the S/T version of DIVA
Mobile, you must install an NT1 between the ISDN wall jack and the
card (connect the DIVA Mobile to the NT1, and the NT1 to the ISDN
wall jack). You can obtain an NT1 from your Eicon Technology
supplier or from a third party.
2 And/Or connect the modem’s RJ 11 cable to an analog wall jack either
directly (North America only) or via a corresponding teleadapter.
Changing SPIDs and ISDN Numbers
To enter or modify your ISDN telephone number and/or SPID (Service
Profile Identifiers) follow these steps:
1 Click Start on the Windows 95 Taskbar. Go to Programs/DIVA for
Windows 95 and select Setup Wizard.
2 Follow the Setup Wizard instructions, adjusting the ISDN numbers as
necessary. Note that SPIDs are used only in North America (if
required).
3 You must Shutdown and reboot your system for the new settings to
take effect.
Removing
Note: If you want to remove the DIVA Mobile and the DIVA Mobile
Windows 95 drivers, you must use the Device Manager. You can only remove
the DIVA Mobile software if the DIVA Mobile PC Card is inserted in your
Notebook.
1 From Taskbar select Start, Settings and then Control Panel.
2 Double-click the System icon in the Control Panel window.
3 Select the Device Manager tab.
4 Double-click the Multifunction adapter entry; (if not found, double-
click the Modem entry).
5 Select the DIVA Mobile ISDN-V.34 combo card and click Remove.