Eaton Electrical D77A - Manual (Page 56)

Intelligent Technologies ( IT.) D77A I/O Module Products
48 For more information visit: www.EatonElectrical.com MN05002001E
Appendix A
Data Parameters
Table 33: 0x0001 (1) Production Data
Table 34: 0x0002 (2) Consumption Data
Table 35: 0x0003 (3) QCPort Status
Table 36: 0x0004 (4) Application Status (Available in I/O As Control Elements)
Table 37: 0x0005 (5) Discrete Data Input (Available in I/O As Control Elements)
Table 38: 0x0006 (6) Discrete Data Output (Available in I/O As Control Elements)
Table 39: 0x006B (107) Analog Input Status (Available in I/O As Control Elements)
* Setting the bit from “0” to “1” indicates that the condition is true.
Size Description
Varies This list contains the concatenated values of QCPort Parameters specified in QCPort Configuration Parameter
0x800C, Production List.
Size Description
Varies This list contains the concatenated values of QCPort Parameters specified in QCPort Configuration Parameter
0x800D, Consumption List.
Size Description
1 Byte This parameter indicates the QCPort fault condition that caused a device to enter the Fault Mode, as indicated
below:
0x00 — No QCPort Fault
0x01 — Node ID Conflict
0x02 — Invalid Node ID in Master/Slave
0x03 — Physical Node ID does not match actual ID
0x04 — Duplicate configured nodes online
0x05 — Dynamic Node ID overflow
0x06 — Invalid baud rate selected
0x07 — Errant Device fault
0x08 — Problem with data in non-volatile memory
Size Description
2 Bytes This parameter indicates the application status of the QCPort device. It reports the most recent fault or warning.
If there have been no faults or warnings, it reports 0. Reset clears this parameter.
Size Description
n Bytes A series of BYTES that represent discrete digital inputs on a device. This parameter is used in any input module
having discrete inputs.
The least significant bit of byte 0 corresponds to input point 0.
Size Description
n Bytes A series of BYTES representing the state of the outputs of a discrete output device. This parameter is used in
any module having discrete outputs. The least significant bit of byte 0 corresponds to output point 0.
Parameter 0x8023, “Output Comm Loss Behavior” is used in conjunction with this parameter.
Size Description
n Bytes This provides channel status for the analog inputs.
U = Under Range
O = Over Range
Byte Bit 7 Bit 6 Bit 5 * Bit 4 * Bit 3 Bit 2 Bit 1 * Bit 0 *
0 O1 U1 O0 U0
1 O3 U3 O2 U2