High End Systems Roadster Orbital Head System - Manual (Page 20)

CHAPTER 2
Setup and Configuration
10 Roadster Orbital Head System User Manual
3. Remove the three existing
projector M10 x 20mm hex bolts
and lock washers (B).
4. Retract projector foot (C) to
minimum height to accommodate
the bracket.
5. Slide the bracket over the
projector.
6. Insert the three provided spacers
(D) between the bracket and the
projector
7. Reinstall the three hex bolts and
washers (B) through the spacers.
8. If you are not using the lifter eyes
on the projector for truss mounting,
install the optional M12 x 35mm
hex bolt, lock washer and flat
washer (F) provided to secure the
bracket to the projector.
Mounting the Power Hub
Attach one or two cheeseborough
clamps to the mounting bracket for
mounting on any standard truss. Use
safety cable to secure the Power Hub to
an independent support.
Note: The Power Hub must be located
within two meters of the
projector head for correct
performance.
C
B
D
F
B
Mounting bracket
Locking washer
Flat washer
Locking
Flat
washer
washer