High End Systems Roadster Orbital Head System - Manual (Page 37)

CHAPTER 3
Operation and Maintenance
Roadster Orbital Head System User Manual 27
Fixture Hours
Use this option to view the fixture operation time in hours and minutes.
Fixture Hours Reset
Use this option to reset the fixture operation time to Zero.
To access the FIXTURE HOURS RESET option:
1. Press the Menu button to unlock the menu system or to move back up the system to the
top level menus.
2. Use the left and right arrows on the Navigation button to scroll to the INFORMATION MENU
and press the Enter button to select.
3. Use the left and right arrows on the Navigation button to scroll to the
FIXTURE HOURS RESET option and press the Enter button to select.
4. Use the up and down arrows on the Navigation button to scroll to YES. Press and hold the
Enter button down for 5 seconds to select.
Module Version Menu
This option display’s the hardware and software version number for each logic board in the
fixture as a troubleshooting method for checking communication with the different boards
inthe fixture. Displays NOT AVAILABLE if a board does not exit in that position.
Note: Due to programming functionality, the Display option always
displays NOT AVAILABLE. even though communication with the
board is active whenever you can view the display.
Next DMX Channel
Use this option to view the next available DMX start channel on the link following this fixture
and is based on the fixture’s specific configuration. The value displayed uses the formula
(current Start channel + channels needed for this fixture +1).
Sensor Status Menu
The Sensor Status displays the current numeric position of the fixture’s encoders.
To view encoder values:
To access the DMX VALUES MENU:
1. Press the Menu button to unlock the menu system or to move back up the system to the
top level menus.
2. Use the left and right arrows on the Navigation button to scroll to the INFORMATION MENU
and press the Enter button to select.
3. Use the left and right arrows on the Navigation button to scroll to the SENSOR MENU and
press the Enter button to select.
4. Use the left and right arrows on the Navigation button to scroll to view
MIRROR 1 ENCODER or MIRROR 2 ENCODER value.