HP 3300mfp - Manual (Page 113)

EN Installing the 310x print server 111
Installing the 310x print server
The HP Jetdirect 310x has a single USB port and an RJ-45 network port (10/100Base-Tx) for
connecting to a network. The following items are included with your HP Jetdirect 310x:
● Power module
● Clip (attached to server)
● USB cable
To connect the product to a network
Use the procedure in this section to connect your HP LaserJet 3300
series product to the network using an HP Jetdirect 310x print server.
Note
The instructions below apply to the HP Jetdirect 310x that is included
with the HP LaserJet 3320n. If you are using a different Jetdirect print
server, you must refer to the installation instructions that came with that
print server.
Note
The USB cable should already be connected to the product. (For more
information, see
Connecting a printer cable to your product .)
1 Plug the rectangular end of the USB cable, with the USB symbol
facing up, into the USB socket on the front of the print server. Make
sure the cable is fully inserted.
2 Attach the print server to a 10/100Base-Tx local network by
plugging the network cable into the network port on the rear of the
print server.
3 Plug the power module (supplied with the print server) into a power
outlet. Plug the other end of the power module cable into the power
socket on the rear of the print server.
1
2
3