HP 3300mfp - Manual (Page 209)

EN Interpreting the configuration page 207
12
LAN ERROR- NO LINKBEAT With a 10/100Base-Tx port connected, Link Beat is not sensed. Check the
network cable, and verify that the concentrator or hub is providing Link
Beat.
13
NETWORK RECONFIG- MUST
REBOOT Reset or power cycle the print server to enable the new configuration
values.
15
CONFIGURATION ERROR The configuration information for the NetWare functions is not stored
correctly on the print server. Use the installation software, embedded web
server, or other tools to reconfigure the print server. If this error persists,
there may be a problem with the print server.
16
NOT CONFIGURED The print server has not been configured for NetWare. Use the installation
software, embedded web server, or other tools to configure the print server
for NetWare networks.
17
UNABLE TO FIND SERVER The print server was unable to find the NetWare print server (in Remote
Printer mode) or file server (in Queue Server mode). There was no
response to service queries for advertising print servers or file servers that
matched the configured print server or file server name.
Make sure that the print server or file server is running and that the print
server or file server name configured on the print server matches the actual
name used by the print server or file server. Also make sure that all cables
and routers are functioning correctly.
18
PASSWORD ERROR The print server detected that the password for the NetWare print server
object is wrong. Use a NetWare utility (such as PCONSOLE) to erase the
password for the print server object. When the print server logs on again, it
sets a new password.
Note: When multiple file servers are configured, the error is only displayed
on the configuration page if none of the file servers are connected.
19
NO QUEUE ASSIGNED The HP Jetdirect print server detected that the print server object has not
been assigned any queues to service. Assign queues to the print server
object using printer installation or NetWare utilities.
Note: When multiple file servers are configured, the error is only displayed
on the configuration page if none of the file servers was successfully
connected.
1A
PRINTER NUMBER NOT
DEFINED A NetWare printer number for this printer has not been configured. Assign a
valid printer number to the print server. Use a NetWare utility (such as
PCONSOLE), the Jetdirect embedded web server, or another tool to assign
a printer number.
1B
PRINTER NUMBER IN USE The NetWare printer number assigned to the printer is already in use by
another printer. Assign an unused printer number. This may also occur
when a printer is power cycled, in which case the error goes away after the
print server times out and detects the lost connection.
Error Code and Message Description